Infrared Human Induction Switch,Adjustable

Infrared human induction switches,energy saving,High sensitivity,adjustable

          Factory default is when light is insufficient, the lamp will light. If connected to the lamp, the photosensitive potentiometer in general is not needed to adjust!!! (With the correct method, the photosensitive potentiometer is easily adjusted!)

        On the outside, you can adjust the delay time with a small " ----" type screwdriver, the maximum angle is about 240 degrees. The factory default time is 10 seconds, the times vary range from 10 to 350 seconds, time and the adjusting angle is about proportional.

Product features:

1 wide working voltage: AC110V--250V (suitable for all over the world voltage).

2. Single line system: the connection method is same with the general manual switch.

3 Can connect to the load that the average induction switch is unable: such as energy-saving lamps, incandescent lamp ( bulb ), old fluorescent lamp ( inductance type starter ), electronic fluorescent lamp, T5 lamp, lighting, transformers, small appliances, electromagnetic valve, mixed load ( a variety of different load connected to together) ... All kinds of load!

4. Wide delay time adjustment: about 10 seconds to 6 minutes.

5 Sensitivity is adjustable: day or night lights on or off, is optional, more humane!

6 effective in preventing the power fluctuations, electromagnetic interference, more stable performance, avoids turning on or off the lamps caused by the electromagnetic interference when turn on the other appliances and mobile phone. Thereby more energy can be saved and prolong the service life of the lamp!

7: lightning protection function: there are the lightning protection components, which can effectively prevent the lightning transient pressure damage to the switch.

Installation instructions;

1. Turn off the power.
2. Directly replace the common switch, the connection way is the same.
3. You can mount it on the wall or on the ceiling,
4. if you install an light which give off a lot of heat such as incandescent lamp, the induction switch should keep away from it about one meter.
5. At the first connecting to circuit, it should be initial about 1-3 minutes(at this time it will on or off automatically, it is normal)
6. At daytime or under a strong light, when you install the switch, the light is off. At night or under the insufficient light, the lamp will be on)

   If you interest in this products, please let us know immediantely, and we can confirm it, make sure everything is OK.